Options...

Changes user options for the environment. The Options dialog appears, where you can set up options related to the RTflow application.

General page

Options, General Page

Maximum signals data buffer size. The size in megabytes that the simulator data buffer is allowed to grow to. The simulator will halt when it needs more memory than this to store the simulation result. Increase this value to allow the simulator to run further.

Maximum undo stack size. The size in kilobytes of the editor undo stack. Increase this value to be able to undo more editing operediting operations.

Minimum files in common save dialog. The minimum number of files that must be modified if the common save dialog (described in the Close All section) is to be used, rather than prompting to save each modified individually, when the project is closed. Increase this value to avoid getting the common save dialog when only a few files have been modified.

Open last project when RTflow starts. When checked, RTflow will open the last opened project on startup.

Schematic Editor page

Options, Schematic Editor Page

Default properties for new schematics. These options determine the schematic properties for all new schematics that are created with the New Schematic command. Refer to the Schematic Properties section for information about these properties.

Availability

Always available.