Compiler Errors

The following table summarizes error messages that may be output to the message view as a result of a Compile, Simulate or Generate Code command. Detailed descriptions of the cause of these errors and suggestions for how to resolve them are given in the subsequent subsections.

Notice. The compiler may output error messages that are not listed here. There may be two different reasons for this:

A project or a schematic file has been modified manually.
There is an internal error in the compiler. In this case, it should be reported in the RTflow forums.

Number	Message
2001	Causality loop involving the following signals: signals
2002	Output port has no source in node node.
2006	Recursion in node node.
2007	Equation equation not resolved in node node.
3004	Unbound input port in equation equation of node node.
3017	Type mismatch for signal signal (type1 / type2) in node node.
4001/4101	Could not open template file filename.
4002/4102	Could not open filename for writing.
4004/4104	Error writing filename.
4010/4110	Unknown key key.